Post by Rick Barbee on Apr 21, 2023 14:37:59 GMT -6
Lathe Built Homemade Broadhead Adapter Finalized.
These are total glue on. The adapter glues in the broadhead, and into/over the arrow shaft. It's one solid hook up.
The adapter is 1" long.
It has a head of 3/8" diameter by 1/4" long with a 45 degree by 1/8" camfer at the opening.
The 5 degree taper is cut in to 11/32, then is 3/4" long.
The 8/32 all thread steel pin is 1-13/16" long, and screws into the small end of the adapter 1/8" deep, and secured with JB-Weld.
It is dead on the target weight of 80 grains.
These are total glue on. The adapter glues in the broadhead, and into/over the arrow shaft. It's one solid hook up.
The adapter is 1" long.
It has a head of 3/8" diameter by 1/4" long with a 45 degree by 1/8" camfer at the opening.
The 5 degree taper is cut in to 11/32, then is 3/4" long.
The 8/32 all thread steel pin is 1-13/16" long, and screws into the small end of the adapter 1/8" deep, and secured with JB-Weld.
It is dead on the target weight of 80 grains.
The .002" glue gap was filled with teflon tape for the spin test, and the test done with a Jerry Hill - Killer broadhead.
I'm one Happy Camper ! 
