|
Post by Rick Barbee on Oct 19, 2021 9:24:21 GMT -6
Ready To Rock ! I'm leaving here in a bit to go to my daughters. Won't be back till tomorrow sometime, but I'm going hunting Thursday afternoon. Quiver full of arrows tipped with Jerry Hill broadheads (so sharp they make your eyes bleed just to look at them), and a couple of real mean VPA SGT's The JH arrows range in weight from 667 to 670 grains. I used the long heavier adapters this time, with a little longer footings. That made the difference, but at 20 yards that extra weight isn't showing any drop compared to my 635gr arrows. I think I'm good to go.
|
|
|
Post by Rick Barbee on Oct 19, 2021 9:42:49 GMT -6
These are all completely glue on/in. The adapters are turned down to fit snug "inside" the shaft. The footings for the outside are made from 1916 aluminum, and fit snug. All glued up with Gorilla glue original. The only difference from what you see here is, this time I used pieces of Legacy shafts for the footing, and I used the long adapters. It's not going to break, or come apart.
|
|
|
Post by Rick Barbee on Oct 19, 2021 9:50:42 GMT -6
Pretty much could say - It's all welded together, BUT it's heat reversible just in case.
|
|